Brand-X: Ascend Dropper Seatpost

The Ascend Dropper lever
Ascend: Dropper lever
Ascend: Dropper lever
Dan Joyce's picture

Brand-X: Ascend Dropper Seatpost

Cycle magazine editor, Dan Joyce, puts the Brand-X Ascend Dropper Seatpost through its paces.


Dropper seatposts are great. Being able to lower (then raise) the saddle while you ride along makes a mountain bike much more manoeuvrable. A dropper post can also help cyclists with mobility issues, being lowered for mounting and dismounting then raised for riding along. If you’re not already sure you need one, however, the price might put you off; the iconic RockShox Reverb has an RRP of £284 and upwards. This Brand-X Ascend is just £139.99, discounted to £99.99 on at time of writing. It’s cheap enough to buy speculatively.

What’s perhaps surprising is how good it is. I’ve used RockShox Reverbs, as well as droppers from KS, and the Brand-X Ascend compares pretty well. It works in the usual way, which is to say: like an office chair. You press the release lever and your weight pushes the seat down – either fully or, if you prefer, partially. Press the lever when you’re not sitting and pneumatic pressure pushes the seat back up to its original position.

The Ascend is actuated by a remote lever on the handlebar, which is a much better option than a lever under the saddle. Not having to ride one-handed means you drop the saddle more easily and more readily; on some rides, I use the dropper remote nearly as much as the gear shifter. It’s operated by a standard gear cable.

This version is a ‘stealth’ one, designed for internal routing through the seat tube and (on suitable frames) the down tube. Fitting is a bit of faff as you need to get the cable length just right, but the cable end attached to the seatpost yoke isn’t easily accessible like a gear or brake cable would be: it’s in the frame. Measure twice, cut once! And don’t forget a spoke for fishing the cable out of the frame… It would be easier to fit if the cable could be trimmed at the lever end. 

Once set up, the Ascend works well, smoothly descending and ascending through 115mm of its nominal 120mm travel. I’ve been using silicone spray after rides to prevent stiction and have had zero problems. Keeping it clean obviously helps; I’m using a Mudhugger rear guard. There’s a little rotational play between the upper and lower shafts, but not enough to bother me.

The only issue is that, like most droppers, it’s an inline post. As I normally use a layback post, that shortened the distance to the handlebar by about 20mm, making it feel cramped. I fitted an 80mm stem in place of the existing 60mm, but would prefer a shorter stem and a layback dropper. A longer frame would work too but would be more expensive to buy than a different dropper.

The Brand-X Ascend is available in 30.9 and 31.6mm diameters and with a 120 or 150mm drop. There’s an Ascend XL with a 170mm drop, as well as an Ascend II, for bikes without internal routing, in 27.2, 30.9, and 31.6mm diameters, and in 105 and 125mm drops. There’s also a CX one (27.2mm only) in 85 and 105mm drops with a drop-bar lever. The 31.6, 120mm Ascend post I tried weighs about 640g, including lever and cable. It’s a penalty of 300-400g over a rigid post but one that’s worth paying. If it came to a choice between a suspension fork and a dropper, I’d pick the dropper.

Brand-X Ascend dropper seatpost

Pros and cons

+ Inexpensive
+ Surprisingly good
- Like most, inline only

Other options

KS Eten Integra

KS Eten Integra £130

Cable-operated layback post available in 30.9 and 31.6mm with 125mm travel and in 27.2mm with 100mm travel. KS eTen Remote version is externally routed.

Rockshox Reverb Stealth

Rockshox Reverb Stealth £328

Hydraulically actuated, internally routed post available in 30.9, 31.6 and 34.9mm diameters, with 100, 125, 150, and 170mm travel. External version is cheaper.

Sponsored Advert
Sponsored Advert
Sponsored Advert
Sponsored Advert
Sponsored Advert